Differences

This shows you the differences between two versions of the page.

Link to this comparison view

reference:ft_topoplotcc [2018/08/23 14:43] (current)
Line 1: Line 1:
 +=====  FT_TOPOPLOTCC =====
 +
 +Note that this reference documentation is identical to the help that is displayed in MATLAB when you type "help ft_topoplotCC"​.
 +
 +<​html><​pre>​
 +  <a href=/​reference/​ft_topoplotCC><​font color=green>​FT_TOPOPLOTCC</​font></​a>​ plots the coherence between channel pairs
 + 
 +  Use as
 +   ​ft_topoplotCC(cfg,​ freq)
 + 
 +  The configuration should contain:
 +    cfg.feedback ​   = string (default = '​textbar'​)
 +    cfg.layout ​     = specification of the layout, see <a href=/​reference/​ft_prepare_layout><​font color=green>​FT_PREPARE_LAYOUT</​font></​a>​
 +    cfg.foi ​        = the frequency of interest which is to be plotted (default is the first frequency bin)
 +    cfg.widthparam ​ = string, parameter to be used to control the line width (see below)
 +    cfg.alphaparam ​ = string, parameter to be used to control the opacity (see below)
 +    cfg.colorparam ​ = string, parameter to be used to control the line color
 + 
 +  The widthparam should be indicated in pixels, e.g. usefull numbers are 1
 +  and larger.
 + 
 +  The alphaparam should be indicated as opacity between 0 (fully transparent)
 +  and 1 (fully opaque).
 + 
 +  The default is to plot the connections as lines, but you can also use
 +  bidirectional arrows:
 +     ​cfg.arrowhead ​   = string, '​none',​ '​stop',​ '​start',​ '​both'​ (default = '​none'​)
 +     ​cfg.arrowsize ​   = scalar, size of the arrow head in figure units,
 +                        i.e. the same units as the layout (default is automatically determined)
 +     ​cfg.arrowoffset ​ = scalar, amount that the arrow is shifted to the side in figure units,
 +                        i.e. the same units as the layout (default is automatically determined)
 +     ​cfg.arrowlength ​ = scalar, amount by which the length is reduced relative to the complete line (default = 0.8)
 + 
 +  To facilitate data-handling and distributed computing you can use
 +    cfg.inputfile ​  ​= ​ ...
 +  If you specify this option the input data will be read from a *.mat
 +  file on disk. This mat files should contain only a single variable named '​data',​
 +  corresponding to the input structure. For this particular function, the input should be
 +  structured as a cell array.
 + 
 +  See also <a href=/​reference/​ft_prepare_layout><​font color=green>​FT_PREPARE_LAYOUT</​font></​a>,​ <a href=/​reference/​ft_multiplotCC><​font color=green>​FT_MULTIPLOTCC</​font></​a>,​ <a href=/​reference/​ft_connectivityplot><​font color=green>​FT_CONNECTIVITYPLOT</​font></​a>​
 +</​pre></​html>​